Re: [AMMRL] Eject air pressure psi? #varian

From: Frank Bennis <fjbennis_at_gmail.com>
Date: Tue, 1 Oct 2024 19:05:05 -0400
Hi Emily
          Greg is spot on except probes 
With the gradient pins need to be aligned BEFORE. Pushing up 
Take probe out ,push upper barrel 
Down mark top of upper barrel 
So you know if it moves.     Insert probe
And gently push up rotating the probe until the guide pin alignes with upper
Barrel .   This should be done without 
Upper barrel moving .   Obs early mark
If moved you can push back down
Adjust probe mounting bracket 
May have to rotate probe and upper barrel to align vt air connection .
       If all done right sample should 
Float with about same pressure as your other probes.  
        Good luck 
           Frank


On Oct 1, 2024, at 2:55 PM, gregory.wylie via groups.io wrote:


Hi Emily
 
It actually maybe that the probe is not seated with the upper barrel well. This is easier with 2 people. But loosen the probe collar with the Allen wrench, and push up on the probe. This will push the upper barrel up. Then push the upper barrel back down. This should seat them together well. Retighten the probe collar. 
 
This is the main cause I have seen over the years.
 
Greg
_._,_._,_
Groups.io Links:

You receive all messages sent to this group.

View/Reply Online (#1= 685) | Reply To= Group | Reply To Sender | Mute This Topic | New Topic
Mute #varian
Your Subscription | Contact Group Owner |

_._,_._,_
--Apple-Mail-EB926E2D-3326-4EB1-81AF-1A7CAE96FD37-- Received on Tue Oct 01 2024 - 16:47:06 MST

This archive was generated by hypermail 2.4.0 : Fri Nov 01 2024 - 17:08:12 MST