Hello Spinlanders,
I am puzzled. I looked through the archives wrt above and everyone talks
about the Aspect monitor have an eight pin connector. Our Aspect monitor
has a nine pin female connector. Folks go on to say how an adaptor can be
made to allow the eight pin male output from the Aspect video cable to
connect to a CGA monitor's nine pin connection. I have an old 17 inch
Leading Edge monitor (circa 1993) that has a 15 pin male D-SUB connector.
The monitor also has three BNC connectors for red, green, and blue video
input. A switch on the front of the monitor allows one to switch between
D-SUB and BNC video input. There is another BNC connector for input of 5
volts. Two switches on the rear panel allow one to select between 75 ohms
and OPEN and 75 ohms and TTL
Can some kind sole help me to mate the Aspect 3000 video signal with above
monitor?
Lawrence Byrnes,
NMR Laboratory Manager,
Numare Spectralab Incorporated
Research Director,
The Schoenenberg Institute of Molecular Spectroscopy
10 Summit Avenue, Building #6, P.O. Box 96,
Berkeley Heights, NJ, 07922-0096,
Voice: 908-665-0066
Fax: 908-464-4192
E-mail: numare_at_eclipse.net
Web: http://www.eclipse.net/~numare/
IMPORTANT NOTICE! PLEASE READ!
THIS EMAIL, AND ANY FILES TRANSMITTED WITH IT, ARE CONFIDENTIAL AND
INTENDED SOLELY FOR THE USE OF THE INDIVIDUAL OR ENTITY TO WHOM THEY
ARE ADDRESSED. IF YOU ARE NOT THE INTENDED RECIPIENT, YOU ARE NOT
PERMITTED TO DISTRIBUTE OR USE THIS MESSAGE OR ANY OF ITS ATTACHMENTS
IN ANY WAY. WE ALSO REQUEST THAT YOU ADVISE THE SENDER OF THE INCORRECT
ADDRESSING. THIS NOTICE ALSO CONFIRMS THAT THIS EMAIL MESSAGE HAS BEEN
VIRUS SCANNED AND THAT, ALTHOUGH NO COMPUTER VIRUSES WERE DETECTED,
NUMARE SPECTRALAB INCORPORATED ACCEPTS NO LIABILITY FOR ANY CONSEQUENTIAL
DAMAGE RESULTING FROM EMAIL CONTAINING ANY COMPUTER VIRUSES.
Received on Fri Aug 23 2002 - 17:32:17 MST