Colleagues
Thanks to those who responded to my previous cry for help. Turns out that
after setting the serial configurations I needed to power off then on the
plotter. Vnmr now communicates with the plotter.
However, the plot is off the page in the lower left corner; ie a 1D
spectrum normally begins at the lower left corner of the page. These plots
begin lower left but off the page in both x and y dimensions. On the
plotter menu, I have selected plot format>drawing size>ANSI A>E.
Presumably this sets ANSI protocol and page size E. Do any of you have a
suggestion for how to get the plot properly placed on the page?
Thanks!
Dr. Joseph Vaughn
Associate Director, NMR Facility
Chemistry Department
Florida State University
Tallahassee, FL 32306-4390
Phone 850-644-3334
Fax 850-644-8281
email vaughn_at_sb.fsu.edu
http://www.chem.fsu.edu/faculty/vaughn.htm
Received on Fri Aug 04 2000 - 12:43:47 MST